Job Description

Job description

ELECTRICAL MECHANIC

Hourly rate: $35-45/hour plus 10 hours overtime weekly (time and a half pay)

Duties and Responsibilities

· Must be familiar with the NEC & how to lookup & perform work to minimum NEC Standards

· A thorough understanding of electrical theory, ohms laws, induction, capacitive, true power, reactive power, apparent power, etc.

· Must be familiar with the basic tools of the trade including ammeters, ohm meters, VOM, Meggars, EMT benders, Ridgid Hydraulic Benders, wire baskets, pullers & setup, thermal scanners, cable testers.

· Adhere to state and local building regulations

· A good foundation is basic relay logic & be able to demonstrate this

· Transformer connections, H1, H2, X1, X2 etc.

· Be familiar with single phase as well as 3 phase distribution systems

· Be able to size wire using ampacity tales

· Be capable of sizing conductors & know percent fill of each size or demonstrate knowledge of how to obtain this info

· Knowledge of a phase & single phase motor connections

· Capable of planning electrical jobs including selecting all types of boxes, panels, breakers, fuses, conduit, wire size, grounding conductors, etc.

· Bending EMT 1/2“ through 1”

· Be capable of trouble shooting without issues with & without a schematic

· Being capable of tracing wires & capable of creating schematics as needed

· Familiar with VFD’s & being capable of programming them as well as trouble shooting them.

· Be familiar with the tools of the trade & how to use them properly

· Complete work orders on time

· Perform all work in a neat & workman like manner, clean up after yourself

· Tighten all fittings, clamps, Seal-tite connections, termine screws to the proper torque setting

· Knowledge of lockout tagout procedures & implementation of them

· Proper use of arial lifts, turret lifts, ladders & scaffolding as well as forklift operation

· Able to perform lifting, bending to OSHA Standards

· Knowledge of fasteners & their proper use

· Knowledge of instrumentation & control – 4-20mm – 0 -10V circuit

· Knowledge of:

· photo eyes in both light & dark modes of operation

· pressure switches

· limit switches

· VFD’s & motor starters

· flow & level sensors

· IP transducers

· Relays

· HMI equipment

· temperature devices

· Capable of ballast & light/lamp changes

· PLC skills

o Familiar with converting relay logic into ladder logic

o Familiar with Allen Bradley communications protocol path highway, ethernet, etc.

o Familiar with IO selection & troubleshooting & configuration.

o Installation & maintenance of PLC’s & associated equipment

o HMI programming & troubleshooting

Job Type: Full-time

Pay: $35.00 - $45.00 per hour

Expected hours: 40 – 55 per week

• Marlboro, NY: Relocate before starting work (Required)

Job Tags

Similar Jobs